Brands: Ford / Ford New Holland / New Holland Agriculture
Equipment Type: Baler / Baler Components
Manuals Type: Service Manual
Machine Model & Serial Number: 67, 68, 69, 268, 269, 270, 271, 272, 273, 275, 276, 277, 278, 310, 311, 315, 316, 320, 326, 565, 570, 575 and Self-Propelled Balers
Region: N/R
Book Code: 40331203
Issued: Printed in U.S.A. Issue 9-90
Language: English
Pages: 52
File Format: Portable Document Format (PDF)
Remark: Massive complete factory service manual focusing specifically on the heavy-duty drive components. Extremely valuable: Contains deep-level overhaul and rebuild procedures for the Main Drive Gearboxes (14x18 and 16x18 balers), Feeder Drive Gearboxes, and the complete Transmission and Rear Axle Assembly for Self-Propelled Balers. Note: Does not include internal engine overhaul procedures.
Table of contents
- SECTION 1 - MAIN DRIVE GEARBOX - 14 x 18 BALERS
- Models Covered: 67, 68, 69, 268, 269, 270, 271, 272, 273, 275, 276, 277, 278, 310, 311, 315, 316, 320, 326, 565, 570 AND 575
- Gearbox Removal and Disassembly
- Pinion Shaft and Main Shaft Inspection
- Gearbox Assembly and Bearing Preload Setup
- Ring Gear and Pinion Backlash Adjustment
- SECTION 2 - MAIN DRIVE GEARBOX - 16 x 18 BALERS
- Models Covered: 78, 280, 281, 282, 283, 286, 290, 320, 420, 425, 426, 430, 580 AND 585
- Gearbox Disassembly and Parts Inspection
- Reassembly and Tapered Roller Bearing Adjustment
- Shimming and Backlash Calibration
- SECTION 3 - FEEDER DRIVE GEARBOX - ALL MODELS
- Disassembly of Feeder Drive Gearbox
- Inspection of Gears, Shafts, and Bearings
- Assembly, Shimming, and Seal Installation
- SECTION 4 - TRANSMISSION AND REAR AXLE ASSEMBLY SELF-PROPELLED BALERS
- Transmission Removal and Complete Disassembly
- Shift Rails, Detent Balls, and Springs Inspection
- Clutch Release Bearing and Carrier Servicing
- Differential Disassembly and Reassembly
- Final Drive Assemblies and Gear Case Lubrication
Service Techniques
Appropriate service methods and proper repair procedures are essential for the safe, reliable operation of all equipment. Clean the exterior of all components before carrying out any form of repair. Dirt and abrasive dust can reduce the efficient working life of a component and lead to costly replacement. When reassembling gearboxes, always use new oil seals and ensure proper shimming is achieved for correct gear backlash and bearing preload.
